2. REGULATOR:
The regulator allows you to select the amount of air pressure that is output through the air hose into tools and accessories. Please refer to the air delivery requirements of your tools for the proper pressure settings.
3. TANK PRESSURE GAUGE:
The tank pressure gauge provides a reading of the air pressure inside of the compressor tank.
4. SAFETY VALVE:
This compressor is equipped with a safety valve switch that will engage when the pressure in the tank exceeds the maximum rated pressure. DO NOT attempt to modify or remove safety valve.
5. TANK DRAIN FITTING:
Water is produced whenever air is compressed. It is critical to drain water from the air tank on this compressor frequently. If unit is used only occasionally, tank should be drained after each use and prior to the next use. To drain the tank, slowly open the tank drain fitting by turning clockwise. Once all water has drained out, close the fitting securely. NOTE: tank will not pressurize while fitting is open.
6. THERMAL SHUTDOWN SWITCH:
The electric motor is equipped with an automatic thermal overload protector. If the unit is overheating, the motor will automatically shut down. Turn the unit off and wait
If the unit shuts down again, please contact the manufacturer for assistance.
Operating Instructions:
START UP:
1.Slowly open tank drain by turning clockwise. Allow any water in tank to drain out. Close fitting securely.
2.Before connecting the compressor to the grounded outlet, check for broken components and accessories, and check for damage to the hose.
3.Make sure the power switch is turned “O” (OFF) position.
4.Plug the unit into a grounded outlet.
5.Attach desired tool to the end of the air hose.
6.Turn the switch on the “I” (ON) position.
7.Adjust regulator knob to desired pressure level once the pump has shut off and the compressor has stopped running.
STORAGE:
1.Disconnect unit from grounded outlet.
2.Disconnect tools and/or accessories from the air hose.
3.Locate drain valve on bottom side of tank.
4.Open drain valve to release remaining pressurized air and moisture from the air tank. Moisture
5.Close valve and store the compressor in a cool, dry place.
MAINTENANCE:
1.This compressor is supplied with a closed lubrication system, so no lubrication is needed.
2.Periodically drain tank of excess moisture. Excess moisture in the tank will result in wear and tear on tools and
accessories. 3.Fuse Replacement
- Disconnect power cord from electrical outlet prior to fuse replacement. - Replace with 5A 250V Glass Tube Fuse only!