Woodstock W1776 owner manual Clearing Jammed Nails

Page 12

Model W1776 2" Nailer Kit

Clearing Jammed Nails

A jammed nail must be cleared before using the nailer again.

To clear a jammed nail from the dis- charge area, do these steps:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Unlatch and pull the magazine all the way back.

3.Remove the nail stick from the magazine.

4.Open the nailer nose with the nose release lever (see Figure 6).

Nose Release Lever

Nose Cover

Figure 6. Nose opened to clear jam.

5.Remove the jammed nail with a tool that will fit in the slot on the underside of the nose, such as needle nose pliers.

6.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!

7.Close the nose cover, and push the magazine all the way forward until the catch lever locks it in place.

-10-

Image 12
Contents Nailer KIT Page Safety Safety Instructions for Pneumatic ToolsBefore Operating This Equipment Always USE Safety GLASSES. Also use a face or dust mask Additional Safety for Nailers/Staplers Introduction Woodstock Technical SupportTool Data Typical filter/lubricator/regulator installation order Compressed Air SystemSetup UnpackingInventory Model W1776 InventorySafety Nose Mechanism To check the safety nose mechanism, do these stepsOperations LoadingOperating To load your nailer, do these stepsAdjusting Depth To adjust the nail depth, do these stepsClearing Jammed Nails Replacing Pistons Rings Cleaning & Lubrication CleaningLubricatingW1776 Parts Breakdown W1776 Parts List REF PART# DescriptionTroubleshooting Page Warranty Registration BOX BELLINGHAM, WA