Model W1776 2" Nailer Kit
OPERATIONS
Loading
When replacing nails in your Model W1776, follow these guidelines:
Gauge: | 18 |
Length: | |
Capacity: | 100 |
To load your nailer, do these steps:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Press down on the locking catch lever and slide the magazine pusher all the way back (see Figure 2).
Catch
Lever
Figure 2. Releasing locking catch lever.
3.Insert a strip of nails, pointed-end down, into the magazine, as shown in Figure 3.
Figure 3. Loading nails into magazine.
4.Slide the nails all the way down to the nose of the nailer.
5.Push the magazine pusher all the way forward until the catch lever locks it in place.
Operating
If you have not read the safety instructions in this manual, do not operate the nailer.
Before you operate your nailer, place five to six drops of the included oil into the quick connect fitting where the nailer connects to the air supply.
To operate your nailer, do these steps:
1.Connect the air supply to the quick connect fitting.
2.To test for proper nail penetration, hold the nailer perpendicular to the surface of a piece of clean scrap wood that is thick enough for the length of nails you have loaded.