Figure 12. Bottom of rack in position.
Figure 13. Inside bevel in the correct position.
Table Support, Cont.
4.Slide the table support bracket onto the col- umn while holding the rack in place. Allow the bracket to go down until the bottom of the rack contacts the shoulder on the col- umn support. Figure 12. Secure the table with the lock handle.
5.Slide the column ring onto the column with the inside bevel in the down position. Figure 13. Adjust the ring until the tip of the rack fits inside the bevel. Tighten the setscrew on the ring.
NOTICE
Use caution when tightening set screw. Over tight- ening will split column ring.