Woodstock W1680 instruction manual Maintenance, General Table And Base, Lubrication

Page 22

 

MAINTENANCE

General

Table And Base

Disconnect power to the machine when perform- ing any maintenance or repairs. Failure to do this may result in serious per- sonal injury.

Regular periodic maintenance on your Model W1680 Drill Press will ensure its optimum per- formance. Make a habit of inspecting your drill press each time you use it. Check for the fol- lowing conditions and repair or replace when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged drive belts.

5.Any other condition that could hamper the safe operation of this machine.

Tables can be kept rust-free with regular appli- cations of products like Boeshield® T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guardit™.

Lubrication

Since all bearings are shielded and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.

For other items on this machine, such as the quill, table and column, an occasional applica- tion of light machine oil is all that is necessary. Before applying lubricant, clean off sawdust and metal chips.

Your goal is to achieve adequate lubrication. Too much lubrication will attract dirt and saw- dust. Various parts of your machine could loose their freedom of movement as a result.

MAINTENANCE

-21-

Image 22
Contents Drill Press Table Of Contents Woodstock Service and Support Introduction About Your NEW Drill PressWarranty and Returns Machine SpecificationsSafety First Additional Safety Instructions For Drill Presses Extension Cords Electrical Requirements110V Operation GroundingAvoiding Potential Injuries Never drill, holding workpiece by handAssembly Instructions AssemblyBase/Column Secure base to floorTable Support Insert the pinion gear from the insideTable Support, Bottom of rack in positionHead Stock Align pocket in headstock with columnInstalling Light Bulb HandlesDrill Chuck and Arbor Chuck components identificationArbor Removal Seating arbor into spindleAdjustments Speed ChangeSpindle Adjustments More About Speed ChangesTable Adjustments Changing table height with crankOperations Test RunInstalling bit Drill Bit ChangesGeneral Table And Base MaintenanceLubrication Closure Possibility of mechanical damage orYour Notes Parts Base Slide BAR Warranty Card Woodstock INTERNATIONAL, INC
Related manuals
Manual 29 pages 56.23 Kb