Woodstock W1780 owner manual Clearing Jammed Nails

Page 12

Model W1780 11⁄4" Brad Nailer

Clearing Jammed Nails

A jammed nail must be cleared before using the nailer again.

Nose Release

To clear a jammed nail from the dis- charge area, do these steps:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

Nose Cover

Nose Tip

2.Pull back and latch the magazine pusher.

3.Remove the nail stick from the magazine.

4.Open the nailer nose by removing the rubber nose tip, squeezing the nose release mechanism (Figure 6), and opening the nose cover.

Figure 6. Nose opened to clear a jam.

5.Dislodge the jammed nail with a tool that will fit in the slot on the underside of the nose.

6.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!

7.Close the nose cover and re-install the nose tip.

8.Release the catch lever and let the pusher slide to the front of the magazine.

-10-

Image 12

Contents 11⁄4 Brad Nailer Page Safety Safety Instructions for Pneumatic ToolsBefore Operating This Equipment Information about proper operationAlways USE Safety Glasses Additional Safety for Nailers/Staplers Introduction Woodstock Technical SupportTool Data Typical filter/lubricator/regulator installation order Compressed Air SystemSetup UnpackingInventory Model W1780 Inventory QtySafety Nose Mechanism To check the safety nose mechanism, do these stepsOperations LoadingOperating To load your nailer, do these stepsAdjusting Depth Adjusting Depth section on thisTo adjust the depth, do these steps Clearing Jammed Nails Replacing Pistons Rings To replace a piston, do these stepsCleaning & Lubrication CleaningLubricatingW1780 Parts Breakdown W1780 Parts List PART# DescriptionTroubleshooting Page Warranty Registration BOX BELLINGHAM, WA