Woodstock W1672 instruction manual Assembly Instructions, Contents

Page 11

ASSEMBLY INSTRUCTIONS

Figure 10. Components laid out for identification.

The following is a description of the components shipped with the Shop Fox® W1672 14" Bandsaw. It is recommended that the components be laid out in a similar fashion to those in Figure 10. This will help in identification before beginning assembly. Should any part be missing, examine the packaging careful- ly to be sure none are among the packing materials. If any key parts are missing, contact Woodstock International, Inc. at 360-734-3482 or tech-support@woodstockint.com.

1.	Bandsaw Body	8.	Trunnion Support
2.	Cabinet Stand	9.	3⁄8" Bandsaw Blade
3.	Table	10.Table Insert
4.	Fence	11.Miter Gauge
5.	Fence Rails (2)	12.V-Belt
6.	Motor	13.Dust Port
7.	Motor Pulley	14.Bag of Hardware (see next page for detailed
			contents)

10

Image 11

Contents Bandsaw Table Of Contents Introduction About Your NEW Bandsaw Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Additional Safety Instructions For BandsawsGrounding Electrical Requirements110V Operation Extension CordsTypical 220V 3-prong plug and outlet 220V OperationUnplug saw before changing blades Avoiding Potential InjuriesUse push blocks when necessary Contents Assembly InstructionsStand HardwareLifting tensioning handle Bandsaw BodyQuick-Connect Cord Mounting MotorTo mount the table Mounting TableMounting Dust Port Fence/Rails Rail placementLocation of Controls AdjustmentsSpeed Changes Diagram of speed optionsTo remove the blade Install/Remove BladesTo install the blade To tighten your blade by deflection To adjust blade tensionBlade Tension To tighten your blade by soundRead the next section for coplanar tracking To track the blade using center trackingTracking To check if your wheels are coplanar Wheel AlignmentLower wheel adjustment control Blade guide assemblies Blade GuidesGuide block position on blade To adjust the guide blocksTo square the table to the blade Table AdjustmentsTo make the miter gauge slot parallel with the blade Table AdjustmentsTo set the fence so it is parallel to the miter slot Fence AdjustmentsBlade Lead To adjust for blade lead with the fence only optionTest Run OperationsGeneral To perform ripping operations RippingCrosscutting To make curved cuts Cutting CurvesResawing To make stacked cuts To resaw, follow this basic procedureStacked Cuts Blade Teeth Blade SelectionBlade Type Blade WidthLubrication MaintenanceMaintenance Notes Maintenance SchedulePage Closure Page Page Page XPB03 Adapter Warranty Card BOX BELLINGHAM, WA