Woodstock D2058A, D2057A, D2260A instruction sheet Rails secured to fixed corner Brackets Foot Post

D2057A, D2058A, D2260A Mobile Base Instructions

7. Thread (1) 8mm lock nut halfway onto each M8-1.25 X 25 hex bolt with the nylon insert on the nut facing the head of the bolt.

8.Secure each end of the rails to the corner brackets with (2) M8-1.25 x 25 hex bolt and 8mm lock nut assemblies as shown in Figure 15. Tighten the lock nuts against the rail.

Each side rail-to-corner bracket connection must use both hex bolts, making a total of four bolts at each corner, as shown in Figure 15. Do not load a machine onto the base until all of these bolts have been installed and tightened. Loading a machine onto the base before completing assembly can result in the machine falling or tipping over, resulting in serious personal injury.

9.Thread the knobs into the top of each foot post several turns, then insert a foot into the bottom of each foot post, as shown in Figure 16. The magnetized knob shaft should pick up the foot when it comes in close proximity.

10.Thread the knobs down to raise the swivel casters off the floor.

11.Lift the machine into position above the mobile base using any necessary help, and lower the machine onto the corner bracket pads.

12.Check to make sure the machine is properly seated on the pads and that there is no sign of stress or deflection in the mobile base.

—If there is any deflection, immediately remove the machine from the base and check that all fasteners have been tightened and the base is properly assembled. If this does not solve the problem, double check the weight specification of the machine and make certain it does not exceed the load limit listed in Specifications on Page 1.

x 2

x 2

Figure 15. Rails secured to fixed corner

brackets.

Foot Post	Knob
Foot

Figure 16. Installing foot pad and knob

into a foot post.

-7-