Woodstock D4041 instruction sheet Inventory, Assembly

D4041 Miter Saw Stand Instructions

Inventory

In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expediency, replacements can be obtained at your local hardware store.

Box Contents: (Figure 2)		Qty
A.	Stand (not shown)	1
B.	Roller Assembly	2
C.	Roller Crossbar	2
D.	Wheel Brackets	4
E.	Wheels	2
­
Hardware:		Qty
	—Support Braces	2
	—Hex Bolts M8-1.25 x 45	2
	—Hex Bolts M6-1 x 45	12
	—Flat Washers 6mm	12
	—Hex Nuts M6-1	12
	—Lock Nuts M8-1.25	2
	—Knobs M8-1.25 x 50	4
	—Knobs M8-1.25 x 20	2
	—Hex Bolts M8-1.25 x 50	4
	—Hex Nuts M8-1.25	8
	—Flat Washers 8mm	6

Assembly

1.Lay the work stand upside down and unfold the top set of legs (inset in Figure 3). Make sure the locking pins snap into place.

2.Place a wheel bracket on both sides of the wheel and thread (1) M8-1.25 x 45 hex bolt through the assembly (see Figure 3), then secure it with (1)

8mm flat washer and (1) M8-1.25 lock nut.

3.Place each wheel bracket assembly over the stand leg, thread (4) M6-1 x 45 hex bolts through each wheel bracket (see Figure 3), and secure them with flat washers and hex nuts.

4.Unfold the remaining legs; install the support braces between the legs with the remaining M6-1 x 45 hex bolts, flat washers, and hex nuts.

5.Place the work stand upright, move the bottom of the wheels approximately an 1⁄8" above the floor and tighten the hex nuts.

6.Place the roller crossbar between the extension arms and secure them with the M8-1.25 x 50 knobs, as shown in Figure 4.

-2-

BC

D E

Figure 2. Model D4041 inventory.

Figure 3. Wheel assembly.

Roller	M8-1.25 x 50 Knob
Crossbar
		Roller
M8-1.25 x 20 Knob		Assembly

Figure 4. Support roller assembly.