Woodstock D4041 Adjusting Work Stand Extension Arms, Folding Miter Saw Stand for Storage

D4041 Miter Saw Stand Instructions

7. Slide the roller assemblies into the crossbars and secure them with the M8-1.25 x 20 knobs (see Figure 4).

8.	Loosen the T-track lock knobs and adjust the T-tracks
			T-Track
	to the width of your miter saw, then slide the heads
	of two M8-1.25 x 50 hex bolts into each T-track.
9.	Place the miter saw over the bolts, and secure each
		T-Track
	location with one washer and two hex nuts (see
		Lock Knob
	Figure 5); when securing these, tighten the top hex
	nut against the bottom one so they do not work loose
	from the vibrations that occur while cutting.
		Figure 5. Mounting the miter saw.

Adjusting Work Stand Extension Arms

1.Slide the extension arms out to their maximum reach and place a straight 2x4 across the miter saw table and rollers.

2.Loosen the crossbar knobs and rotate the roller assemblies until the rollers almost touch the 2x4, as shown in Figure 6. Then loosen the roller assembly lock knobs, slide the rollers up to touch the 2x4, and re-tighten the lock knobs.

Folding Miter Saw Stand for Storage

1.Remove the support braces, retract the extension arms and rotate the support rollers flat.

2.Push in the locking pins shown in Figure 7 and fold the legs up into the stand.

Figure 6. Adjusting the support rollers.

Locking Pin

Figure 7. Folding the miter saw stand.

-3-