Woodstock W1680 instruction manual Table Support, Insert the pinion gear from the inside

Page 11

ASSEMBLY

Table Support

1.Thread the 12mm table lock handle 3 turns into the table support bracket.

2.Insert the pinion into the hole on the side of the table support bracket from the inside, starting with the pinion shaft. Figure 9. Align setscrew in crank handle with flat, Figure 10, on pinion shaft and secure using the 3mm Allen® wrench provided.

3.Examine the rack and note that the gear teeth extend further on one end than the other.The shorter end must be positioned down. Insert the rack into the table support bracket and align with pocket. The end of the rack where the gear teeth are closest to the end should be positioned down as in Figure 11. The gear teeth on the rack must also face out.

Figure 9. Insert the pinion gear from the inside.

Figure 10. Align setscrew with flat on pinion.

Figure 11. Correct rack orientation.

-10-

Image 11

Contents Drill Press Table Of Contents Introduction About Your NEW Drill Press Woodstock Service and SupportMachine Specifications Warranty and ReturnsSafety First Additional Safety Instructions For Drill Presses Grounding Electrical Requirements110V Operation Extension CordsNever drill, holding workpiece by hand Avoiding Potential InjuriesAssembly Assembly InstructionsSecure base to floor Base/ColumnInsert the pinion gear from the inside Table SupportBottom of rack in position Table Support,Align pocket in headstock with column Head StockHandles Installing Light BulbChuck components identification Drill Chuck and ArborSeating arbor into spindle Arbor RemovalSpeed Change AdjustmentsMore About Speed Changes Spindle AdjustmentsChanging table height with crank Table AdjustmentsTest Run OperationsDrill Bit Changes Installing bitLubrication MaintenanceGeneral Table And Base Possibility of mechanical damage or ClosureYour Notes Parts Base Slide BAR Warranty Card Woodstock INTERNATIONAL, INC

Related manuals

Manual 29 pages 56.23 Kb