Woodstock instruction sheet D4031 Parts, Cut Sequence

D4031 Mortising Kit Instructions

8.Watch the chips coming out of the slot on the shank of the chisel. If you don't see chips or there is a lot of smoke, raise the chisel, turn off the drill press and adjust the drill lower in the chisel. If burning still occurs, lower the speed the drill press. Some burning may occur with certain species of wood regardless of the settings but you will see wood chips while cutting mortises with this tool when it is operating correctly.

9.Check the placement of the cut and make any adjustments to the setup before cutting a valuable workpiece.

Cut Sequence

Cutting mortises that are wider than the chisel must be done in proper sequence for best results. See Figure 8 for one possible sequence that will produce good results.

4 2 3 1

Figure 8. Staggered cut sequence.

D4031 Parts

21

22

23

20

19

18

17

16

14 15

REF PART #		DESCRIPTION
1	XD4031001	ALIGNMENT TOOL
2	XD4031002	CLAMP ROD
3	XD4031003	LARGE T-NUT 5/16-18
4	XD4031004	SMALL T-NUT 5/16 X 18
5	XD4031005	FENCE
6	XD4031006	HOLD-DOWN ROD
7	XPW07	FLAT WASHER 5/16
8	XD4031008	HANDLE MALE 5/16-18 X 2"
9	XD4031009	HOLD-DOWN BRACKET
10	XD4031010	MORTISING CHISEL 1⁄2"
11	XD4031011	MORTISING CHISEL 3⁄8"
12	XD4031012	MORTISING CHISEL 5⁄16"
13	XD4031013	MORTISING CHISEL 1⁄4"
14	XD4031014	SQUARE HD BOLT 5⁄16"-18 X 2"
15	XD4031015	KNOB BOLT

8

7

4

3

1

9

10 11 12 13

6 5

2

16	XD4031016 CONE
17	XD4031017 HANDLE FEMALE 5/16-18"
18	XD4031018 SLEEVE 2.945" X 2.6"
19	XD4031019 SLEEVE 2.6" X 2.366"
20	XD4031020 SLEEVE 2.366" X 2.17"
21	XD4031021 BUSHING PAIR 2.6" X 2.00"
22	XD4031022 BUSHING PAIR 2.6" X 1.88"
23	XD4031023 BUSHING PAIR 2.6" X 1.57"

-4-