D3589 Mini Grinder Set
Sanding Sleeves
The mini grinder set comes with two different sizes of sanding drums and sleeves.
To install a sanding sleeve, do these steps:
1.Remove the screw and flat washer at the top of the sanding drum.
2.Slide a sanding sleeve of the appropriate size onto the drum.
3.Reattach the flat washer and screw.
4.Tighten the screw until the drum begins to place pressure on the inside of the sanding sleeve.
Screw | Cutting Wheel |
|
Rubber Washers Mandrel Post
Figure 3. Installing a cutting wheel.
Cutting Wheels
The process for installing cutting wheels is very similar to installing sanding drums.
To install a cutting wheel, do these steps:
1.Remove the screw and the rubber washers at the top of the mandrel.
2.Fit the cutting wheel between the two rubber wash- ers, as shown in Figure 3.
3.
Polishing Wheels
Both polishing wheels provided with the mini grinder screw onto the same threaded mandrel. Simply screw the polishing wheel onto the polishing wheel mandrel.
DO NOT investigate problems or adjust the mini grinder set while it is run- ning. Wait until the tool is turned off and unplugged.
OPERATIONS