Emerson CF2400WB00, CF2400BZH00, CF2400BC00 Unpacking Instructions, Tools Needed for Assembly

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One wire stripper
Three wire connectors (supplied)	One stepladder

Four T8 25-watt (max.) candelabra base bulbs (supplied)

MATERIALS

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following sizes:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 7). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

9.Two couplings

10.One hairpin clip

11.One clevis pin

12.Eleven 10-32 x 5/8” oval head screws

13.Sixteen 10-32 x 3/8” Phillips pan head screws

14.Sixteen #10 flat washers

15.Three 8-32 x 3/8” pan head screws

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor and housing assembly

b.One motor cover

c.Once ceiling cover

d.Five blade flanges

e.One hanger bracket

f.One hanger ball/downrod assembly

g.One switch housing cover

h.One cover plate

i.One finial nut

j.One uplight lead assembly (used only for remote control operation)

k.Four T8 25-watt candelabra base bulbs

l.One loose parts bag containing:

1.One 5/16-18 x 1/4” setscrew

2.One setscrew wrench

3.Two 1” threaded studs

4.Two 1-1/4” threaded studs

5.Four knurled knobs

6.Four lockwashers

7.Four wire connectors

8. Two pull chain pendants 3

		HANGER BALL/
		DOWNROD
		ASSEMBLY
		HANGER
		BRACKET
	FAN MOTOR	LOOSE
	AND HOUSING
MOTOR		PARTS
	ASSEMBLY
		BAG
COVER
SWITCH	COVER	FINIAL
		NUT
HOUSING	PLATE
COVER
CEILING		BLADE
		FLANGES
COVER