Emerson CF2400ORB00, CF2400BZH00, CF2400BC00, CF2400AB00, CF2400WB00 How to Hang Your Ceiling Fan

11.Use the 10 round recessed holes in the motor hub that are marked with a “5” and install the five blade assemblies in accordance with Step 12. One side of the switch housing has been indented to allow easy access when installing the flange screws.

! WARNING

To reduce the risk of personal injury, do not bend the blade flanges when installing the flanges, balancing the blades, or cleaning the fan. Do not insert foreign objects between rotating fan blades.

12.Attach one blade assembly to the motor hub using two 10-32 x 5/8” oval head screws (supplied) (Figure 6). Do not tighten completely at this time. Install four remaining blade assemblies in the same way. Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. Failure to follow this procedure could result in fan wobble. This completes the blade installation.

BLADE FLANGE

4 5 5

10-32 x 5/8" OVAL HEAD

MOTOR SWITCH SCREWS (2 per blade assmebly)

HUB HOUSING

Figure 6

How to Hang

Your Ceiling Fan

!WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 7).

CEILING

AT LEAST

7'

!WARNING

The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.

1.Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box. (Figure 8.)

!WARNING

Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.

	OUTLET
	BOX
TWO SCREWS
SUPPLIED WITH	HANGER
OUTLET BOX
	BRACKET
	TAB
Figure 8

2.Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 9). Be sure the groove in the ball is lined up with the tab on the hanger bracket (Figure 8).

!WARNING

Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.

NOTE: CEILING COVER,
SUPPLY WIRES AND	OUTLET
FAN WIRES OMITTED
FOR CLARITY.	BOX
	HANGER
	BRACKET
	HANGER BALL/
	DOWNROD
	ASSEMBLY
	THREADED
	STUD (2)
Figure 9

!WARNING

To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.

Figure 7

FLOOR

6