Astro Pneumatic 68022 operating instructions Fasteners

Page 12

2.Insert the fasteners into the Magazine. NOTE: Make sure the fasteners are loaded into Magazine slot head first. See Figure 2, below.

Fasteners

Figure 2

3.Close and latch the Magazine Cover.

4.When ready, turn the Safety Lock (26) to the side and press down on the Trigger to operate.

5.WARNING! There is no contact safety for the Trigger. When the Safety Lock

(26)is disengaged and the Trigger is pressed, the Nailer will fire.

6.Test before first use by driving nails into a sample piece of wood. If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of this tool.

CAUTION! TO PREVENT TOOL AND ACCESSORY FAILURE, RESULTING IN INJURY: Do not exceed the tool’s maximum air pressure rating.

If the tool still does not have sufficient force at maximum pressure and sufficient airflow, then a larger tool may be required

7.Always make sure the Drive Guide (31) is flush against the workpiece during use. Always release the Trigger once the fastener is driven into the workpiece.

8.After use, to prevent accidents:

a.Release the Trigger and set the Trigger’s Safety Lock.

b.Detach the air supply.

c.Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners.

d.Clean external surfaces with clean, dry cloth.

e.Store indoors out of children’s reach.

SKU 68022

For technical questions, please call 1-800-444-3353.

Page 12

Image 12
Contents Gauge AIR PIN Nailer Safety Alert Symbol and Signal Words Symbol Property or statementImportant Safety Instructions Save this ManualPersonal safety GeneralWork area Service Tool use and careAir source Save These Instructions Vibration Precautions Specifications Functional DescriptionUnpacking Components and ControlsSKU 68022 For technical questions, please call 444-3353SKU 68022 For technical Air Tool Spray Gun StationaryQuestions, please call Injury from Accidental Operation Work Piece and Work Area Set Up Operating InstructionsGeneral Operating Instructions Loading the ToolFasteners User-Maintenance Instructions USER-MAINTENANCSClearing Jams For technical questions, please call Troubleshooting Problem Possible Causes Likely SolutionsParts Lists Part DescriptionQty Part Description Qty Record Product’s Serial Number HereAssembly Diagram SKU 68022 For technical questionsLimited 1-Year Warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800