USER-MAINTENANCS
User-Maintenance Instructions
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION, BEFORE ANY MAINTENANCE OR REPAIRS ARE DONE (including clearing jams):
•Wear
•Release the Trigger and set the Trigger’s Safety Lock.
•Detach the air supply.
•Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners.
•Empty the magazine and leave it open during service. The Magazine is
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise, vibration, or leaking air is detected, correct problem before further use.
TO PREVENT EXPLOSION:
Lubricate only with specified lubricants. Lubricate the air inlet using only pneumatic tool oil. Lubricate the internal mechanism using only white lithium grease. Other lubricants may damage the
mechanism and may be highly flammable, causing an explosion.
Note: These procedures are in addition to the regular checks and maintenance explained as part of the regular operation of the
Daily - Air Supply Maintenance: Every day, perform maintenance on the air supply according to the component manufacturers’ instructions. The lubricator’s oil level needs to be maintained and the moisture filter must be regularly drained. Performing routine maintenance on the air supply will allow the tool to operate more safely and will also reduce wear on the tool.
Clearing Jams
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION, BEFORE ANY MAINTENANCE OR REPAIRS ARE DONE (including clearing jams):
•Wear
•Release the Trigger and set the Trigger’s Safety Lock.
•Detach the air supply.
•Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners.
•Empty the magazine and leave it open during service. The Magazine is
1.Disconnect tool from air hose, empty Magazine of fasteners, release any built-
SKU 68022 | For technical questions, please call | Page 13 |