Emerson CF550ORB00, CF550BS00 owner manual WAY Installation

Wall Control Installation (continued)

NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire.

1.Disconnect electrical power to the branch circuit at the circuit breaker or fuse box before attempting to install the ceiling fan wall control into the outlet box.

! WARNING

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

2.Remove faceplate and screws from existing wall control. Pull control out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from control. Do not attempt

to disconnect any wires not already connected to existing control.

3.Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.

4.Connect one black wire of wall control to the “hot” wire. Securely connect wires with wire connectors supplied (Figure 17).

5.Connect one black wire of wall control to the “load” (black) wire in wall box. Securely connect wires with wire connector supplied.

3-WAY INSTALLATION

SCREWS (2)	FAN/LIGHT WALL
	CONTROL				WALL BOX
	BLK	T	HOT
		O
		120V
			AC SOURCE
		T
		O LOAD
	BLACK				U
					D
					N
			G	R	O
	SWITCH COVER		NEUTRAL
			WIRES

DECORATIVE WALL PLATE

Figure 17

! WARNING

Check to see that all connections are tight and that no bare wires are visible at the wire connectors.

6.Screw wall control into wall box using the supplied screws. Leave wall control in “OFF” mode until fan installation is completed.

7.The wall control is supplied with a white, ivory, and almond color switch covers. Choose the finish that best suits your needs and snap the cover onto the wall control (Figure 17).

8.Install decorator wall plate using the two screws provided with wall plate. Leave wall control in “OFF” mode until fan installation is completed (Figure 17).

(One fan controlled by two different wall controls) (See Figures 18 and 19.)

! WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

1.Disconnect electrical power to the branch circuit at the circuit breaker or fuse box before attempting to install the ceiling fan wall control into the outlet box.

! WARNING

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

2.At all wall box locations remove faceplates and screws from existing controls. Pull controls out from wall boxes and determine which wall box contains the “hot” lead and which wall box contains the “load” wire. Also, identify traveler wires which are common to both wall boxes. Disconnect wires from existing controls only. Do not attempt to disconnect any wires not already connected to existing controls.

3.Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.

4.Install a wall control in the wall box containing the “hot” wire first. Connect the black wire of the wall control to the “hot” wire. Securely connect wires with wire connectors supplied.

5.Connect one black wire of the wall control to both remaining traveler wires in the wall box and secure with wire connector supplied.

NOTE: Retrofit 3-way installations are likely to include two traveler wires between the two wall boxes (Figure 19). In new construction, only one traveler wire Is required (See Figure 18).

10 ETL Model No.: CF550