RIDGID SP6490 manual Installing The Table, Installing the Storage Tray

Page 14

Assembly (continued)

Installing The Table

1.Loosen support lock and raise table support by turning table crank clock- wise until support is at a working height level. Tighten support lock.

2.Remove protective covering from table and discard. Loosen table lock, place table in table support and tighten table lock (located under table) by hand.

NOTE: If table won’t fit into table support easily, pry open table support with a flat blade screwdriver.

Support Table Lock Support

Column

Table

Support

Support

Lock

Table

Crank

Rack

Table

Table

Lock

Installing the Storage Tray

1.Locate the two piece storage tray, (2) two 5mm dia. x 60 mm long screw, and

(2)two 5 mm hex nuts.

2.Attach to the column as shown. Make sure the storage tray is located above the column collar. Be careful not to over- tighten the nuts.

	Pan Head Screw
	5mm x 60mm	Hex Nut
	(Not Actual Size)	Hex Nut
	(Not Actual Size)	5 mm
		5 mm
	Storage Tray

Column

Collar

14

Image 14

Contents +/225 02/5,//3566 Safety Instructions For Drill Press Table of ContentsBefore Using The Drill Press Reduce the Risk of Dangerous EnvironmentInspect your drill press Thrown WorkpieceThink Safety Plan Your Work This drill press has 12 speeds as listed belowKeep Children Away Dress for safetyReduce the Risk of Accidental Starting Before Leaving The Drill PressGlossary of Terms Motor Specifications and Electrical RequirementsPower Supply and Motor Specifications General Electrical ConnectionsVolt, 60 Hz. Tool Information Properly Prong Plug Grounded Prong Outlet GroundingExtension Cord Gauge Length 25-50 Motor Safety ProtectionWire Sizes Unpacking and Checking Contents Description Qty List of Loose PartsLoose Parts Location and Function of Controls Table Bevel Lock...Locks the table in any position from 0Crank AssemblyAssembly of Base/Column Installing The Table Installing the Storage TrayHead Head Lock Installing the Head10mm Dia. x 12mm Set Screw Head Column Checking Pulleys Alignment Pulley Alignment and Speed AdjustmentSpeed Adjustment Straightedge Lower Belt Motor Tension Mount GuardTensioning Belt Installing Feed HandlesInstalling the Drill Chuck Support Lock Chuck Sleeve Feed Handle Wood Bevel Scale Installing Light BulbAdjusting the Table Square To Head Converting From Right Hand Operation to Left Hand Operation Page Cap Quill Return SpringMm Cap Spring Notch Nut Inner Nut OuterAdjusting Belt Latch Guard Latch Adjusting ScrewsGetting To Know Your Drill Press Spindle Speed in R.P.M Belt Guard Latch...Press button to raise belt guardKey Drilling to a Specific Depth Another Way Depth ScaleRemoving Chuck and Arbor Depth Scale Lock Adjust to Desired DepthLocking Chuck at Desired Depth Chuck Sleeve Chuck BodySafety Instructions for Basic Drill Press Operation Jaws Installing DrillsBasic Drill Press Operation Workpiece Drill Press Vise Bolt or Clamp Vise Securely Workpiece Backup MaterialPositioning Table and Workpiece Feeding Tilting TableHole Location Bevel Lock Set Screw Bevel ScaleTroubleshooting MaintenanceWiring Diagram MaintenanceTroubleshooting Probable Cause Remedy Turn nut counterclockwise toAlways order by Part Number Not by Key Number Repair PartsParts List for Ridgid 15 Drill Press Model No. DP15501 Key DescriptionRepair PartsAlways order by Part Number -- Not by Key Number Description Always order by Part Number Not by Key Number Description Parts List for Rdigid 15 Drill Press Model No. DP15501 Call