RIDGID SP6490 manual Installing the Head, 10mm Dia. x 12mm Set Screw Head Column, Head Head Lock

Page 15

Installing the Head

CAUTION: The head assembly weighs about 80 pounds. To reduce the risk of back injury get help to lift the head.

1.Locate (2) two 10mm dia. x 12mm long set screws in loose parts bag.

2.Remove protective bag from head assembly and discard. Carefully lift head above column tube and slide it onto col- umn making sure head slides down over column as far as possible. Align head with table and base.

10mm Dia. x 12mm

Set Screw

Head

Column

3. Install a set screw in each hole (as indi-		Head	Head Lock
cated) on the right side of the head, and		Head	Head Lock
using a 5mm hex “L” wrench, tighten the			Set Screws
using a 5mm hex “L” wrench, tighten the
two head lock set screws.

15

Image 15

Contents +/225 02/5,//3566 Table of Contents Safety Instructions For Drill PressReduce the Risk of Dangerous Environment Before Using The Drill PressThrown Workpiece Inspect your drill pressThis drill press has 12 speeds as listed below Think Safety Plan Your WorkBefore Leaving The Drill Press Dress for safetyReduce the Risk of Accidental Starting Keep Children AwayGeneral Electrical Connections Motor Specifications and Electrical RequirementsPower Supply and Motor Specifications Glossary of TermsProperly Prong Plug Grounded Prong Outlet Grounding Volt, 60 Hz. Tool InformationMotor Safety Protection Wire SizesExtension Cord Gauge Length 25-50 Unpacking and Checking Contents List of Loose Parts Loose PartsDescription Qty Table Bevel Lock...Locks the table in any position from 0 Location and Function of ControlsAssembly Assembly of Base/ColumnCrank Installing the Storage Tray Installing The TableInstalling the Head 10mm Dia. x 12mm Set Screw Head ColumnHead Head Lock Straightedge Lower Belt Motor Tension Mount Guard Pulley Alignment and Speed AdjustmentSpeed Adjustment Checking Pulleys AlignmentInstalling Feed Handles Installing the Drill ChuckTensioning Belt Support Lock Chuck Sleeve Feed Handle Wood Installing Light Bulb Adjusting the Table Square To HeadBevel Scale Converting From Right Hand Operation to Left Hand Operation Page Nut Inner Nut Outer Quill Return SpringMm Cap Spring Notch CapLatch Adjusting Screws Adjusting Belt Latch GuardGetting To Know Your Drill Press Belt Guard Latch...Press button to raise belt guard Spindle Speed in R.P.MKey Another Way Depth Scale Drilling to a Specific DepthChuck Sleeve Chuck Body Depth Scale Lock Adjust to Desired DepthLocking Chuck at Desired Depth Removing Chuck and ArborSafety Instructions for Basic Drill Press Operation Installing Drills Basic Drill Press OperationJaws Workpiece Backup Material Positioning Table and WorkpieceWorkpiece Drill Press Vise Bolt or Clamp Vise Securely Bevel Lock Set Screw Bevel Scale Tilting TableHole Location FeedingMaintenance MaintenanceWiring Diagram TroubleshootingTurn nut counterclockwise to Troubleshooting Probable Cause RemedyKey Description Repair PartsParts List for Ridgid 15 Drill Press Model No. DP15501 Always order by Part Number Not by Key NumberParts RepairAlways order by Part Number -- Not by Key Number Description Always order by Part Number Not by Key Number Description Parts List for Rdigid 15 Drill Press Model No. DP15501 Call