OPERATION
VARIABLE SPEED CONTROL DIAL
See Figure 2.
The sander has a variable speed control dial, A (slowest) to F (fastest), designed to allow operator control of belt speed. To increase belt speed, turn the variable speed control dial to a higher setting. Turn to a lower setting to decrease belt speed. Refer to the chart on page 10 for proper speed selections.
PROPER HAND PLACEMENT
See Figure 3.
The front and rear handles allow
WARNING:
Keep hands and fingers clear of moving sanding belt, front pulley, and drive roller assembly. Failure to do so will result in the sanding of the hands or fingers possibly causing serious injury.
VARIABLE SPEED
CONTROL DIAL
(A TO F)
Fig. 2
WARNING:
Do not let your fingers rest over the front or right edge of the sander. If the sanding belt were to run off, or if it were not properly adjusted, your fingers could come in contact with the moving sanding belt resulting in possible serious injury.
TURNING ON/OFF THE SANDER
See Figure 4.
To turn on the sander: Depress the switch trigger.
To turn off the sander: Release the switch trigger.
Soft sTaRt feature
Soft start is a feature whereby the motor gradually ramps up to the selected top speed. For example, when a speed is selected with the speed limiting dial and the sander is stopped and then activated again, the sander will gradually ramp up to the previous speed setting once the switch trigger is pressed again.
11
REAR 
HANDLE 
FRONT
HANDLE
KEEP HANDS AND FINGERS AWAY |
|
FROM THESE AREAS AT ALL TIMES | Fig. 3 |
SWITCH
TRIGGER
Fig. 4