Emerson CF4801VNB00, CF4801GBZ00, CF4501GBZ00, CF4801BS00 Unpacking Instructions, Materials

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor and housing assembly

b.One motor cover

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One uplight lead assembly

h.Three 25-watt candelabra bulbs

i.One loose parts bag containing:

1.One setscrew

2.One 5/32" hex wrench

3.Eleven 10-32 x 5/8" oval head screws

4.Two 1” threaded studs

5.Two 1-1/4” threaded studs

6.Four knurled knobs

7.Three wire connectors

8.Two screws, 8-32 x 3/8"

9.Two pull chain pendant and coupling

10.One hairpin clip

11.One clevis pin

12.Two lockwashers

13.Twenty-one #10-24 x 12mm pan head screws

14.Twenty-one flat washers

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove and discard the two cardboard shipping retainers securing the motor hub in the motor housing assembly.

3.Remove the fan motor assembly from the protective plastic bag. Place all carton contents on a protective surface.

CEILING	BLADE	UPLIGHT LEAD
COVER		ASSEMBLY
	FLANGES

3 25-WATT
CANDELABRA	LOOSE
BULBS
	PARTS BAG

FOAM
PACKING	HANGER	HANGER BALL/
	BRACKET
		DOWNROD
		ASSEMBLY
	MOTOR AND
	HOUSING ASSEMBLY

MOTOR

PROTECTIVE COVER

PLASTIC BAG

FOAM

PACKING

CARTON

3 U.L. Model No.: CF4801 and CF4501