Emerson CF705SPB03, CF704SORB03, CF705SWW03, CF705SAW03, CF705SAB03 How to Hang Your Ceiling Fan

How to Hang Your Ceiling Fan

!WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 1).

CEILING

AT LEAST

7'

3.Carefully lift the fan motor assembly and engage the slot in the motor bracket with the hook on the mounting plate so that it is securely suspended (Figure 3). Then connect wiring to your fan according to section "HOW TO WIRE YOUR CEILING FAN".

	MOUNTING
	PLATE
RUBBER
WASHER
THREADED	MOTOR
STUDS

Figure 1 FLOOR

!WARNING

The outlet box and joist must be securely anchored and capable of supporting at least 50 lbs. Use only a U.L. outlet box marked as “Acceptable for Fan Support”.

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

1.Securely attach the mounting plate to the outlet box (Figure 2) using two screws (supplied with outlet box). Pull the black, white and ground wires out of the outlet box through the hole in the mounting plate and lay them to the side as shown in Figure 3.

NOTE: For better fan performance make sure the mounting plate is level. Additional washers (not included) may be needed to insert between the electrical box and mounting plate (Figure 2).

OUTLET BOX

MOUNTING

PLATE

SUPPLY WIRE

LEADS

MOTOR

BRACKET

Figure 3

4. Once wiring is completed, lift the motor bracket so that the four threaded studs on the mounting plate protrude through the four slots in the motor bracket. (See Figure 4.)

Securely tighten the three 1/4” locknuts (supplied) onto the threaded studs, then try to shake the motor bracket to ensure that the assembly is tight. Proceed to section "HOW TO PUT YOUR CEILING FAN TOGETHER".

OUTLET BOX

MOUNTING

PLATE

1/4" LOCKNUTS	MOTOR BRACKET
(3) (SUPPLIED)

FAN MOTOR

SWITCH HOUSING

MOUNTING SCREWS

(SUPPLIED WITH

OUTLET BOX)

Figure 2

PLAIN WASHER

(SUPPLIED)

LEVELING WASHER

(IF REQUIRED)

HOOK

Figure 4

!WARNING

To avoid possible fire or shock, do not pinch wires between the motor bracket and mounting plate.

2.Slide the three rubber washers over the three threaded studs on the bottom surface of the mounting plate.

4