Emerson CF705SORB03 How To Wire Your Ceiling Fan, How To Put Your Ceiling Fan Together

How To Wire Your Ceiling Fan

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.

1.Connect the green grounding wires from the motor bracket and the mounting plate to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation). Securely connect wires with wire connectors (supplied).

NOTE: If you are using an Emerson Light Fixture with your fan, see the Light Fixture Owner’s Manual for wiring.

2.Connect the fan motor white wire to the supply white (neutral) wire using a supplied wire connector (Figure 5).

3.Connect the fan motor black wire and blue wire to the supply black (hot) wire using a supplied wire connector (Figure 5). Your fan is now wired to be turned on and off from the fan switch. After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other side of the outlet box.

!WARNING

SUPPLY GROUNDING

CONDUCTOR WIRE

BLACK SUPPLY (HOT)

WIRE

CONNECTORS

BLUE FAN WIRE

GREEN GROUND WIRE

WHITE FAN WIRE

WHITE SUPPLY (NEUTRAL)

BLACK FAN WIRE

To avoid risk of fire or shock, check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

4. Cut the 3-speed switch pull chain to a desired

length (optional). Connect the wood pendant

(supplied) to the 3-speed switch pull chain by

sliding the wooden pendant (small hole first) onto

the pull chain. Attach the chain coupler to the end

of the chain and allow the wooden pendant to fall

Figure 5

down over the coupling.

5. Return to step 4 of section "HOW TO HANG YOUR

CEILING FAN".

How To Put Your Ceiling Fan Together

1.Align the four holes in the fan housing with the four holes in the mounting plate and install four M5 X 10mm Phillips pan head screws with internal tooth washers (supplied) (Figure 6).

M5 x 10MM PHILLIPS PAN HEAD SCREWS

WITH INTERNAL TOOTH WASHERS (4)

2.Mount the blade flanges to the fan blades using three M5 X 6mm Phillips washer head screws per blade (supplied) (Figure 7). Repeat for four remaining blades.

3.Attach one blade assembly to the motor using the captive screws provided on each flange (Figure 8). Make sure the screws are tightened securely. Repeat this procedure for the other four blade assemblies.

FAN HOUSING

Figure 6

!WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

5 Figure 7

M5 x 6mm PHILLIPS WASHER HEAD SCREWS (3)

CAPTIVE SCREW

BLADE

FLANGE

FAN BLADE