RIDGID R1000 manual To install optional flap disc sold separately

Page 11

ASSEMBLY

•To install optional flap disc (sold separately):

Place the flap disc over the spindle. Thread the clamp nut on the spindle with the flat side of the nut facing up. Fit the raised, small diameter portion of the clamp nut into the hole in the wheel and finger tighten.

WARNING:

Always install a grinding wheel with the depressed center against the flange. Failure to do so will cause the grinding wheel to crack when tighten- ing the clamp nut . This could result in serious personal injury because of loose particles break- ing off and being thrown from the grinder. Do not overtighten.

■Depress the spindle lock button and rotate the wheel clockwise until the spindle locks in position.

■Tighten the clamp nut securely with the wrench provided. Do not overtighten.

Fig. 3a

Fig. 3b

Image 11

Contents Operators Manual Introduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyAdditional Safety Rules Specific Safety RulesService Symbol Name DESIGNATION/EXPLANATION SymbolsElectrical Connection SpecificationsElectrical Double InsulationPacking List UnpackingApplications InstructionsFeatures Guard Attaching the Side Handle AssemblyInstalling Wheels To install optional flap disc sold separately Adjusting the Guard AdjustmentsOperating the Grinder OperationTurning On/Off the Grinder Operation Lubrication MaintenanceGeneral Replacing the GuardPage Page Page DAY Satisfaction Guarantee Policy WarrantyAngle Grinder R1000 Variable Speed Customer Service Information