MAINTENANCE
WARNING:
When servicing use only identical Ridgid replace- ment parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
The angle grinder should never be connected to a power supply when you are assembling parts, making adjustments, cleaning, performing main- tenance, or when the tool is not in use. Discon- necting the tool will prevent accidental starting that could cause serious injury.
General
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.
Replacing the Guard
See Figure 9.
After extended use, the guard may wear and need replacing. If you drop your grinder and damage the guard it may also be necessary for you to replace it.
Follow these steps to replace the guard.
■Unplug the grinder.
WARNING:
Failure to unplug your grinder could result in acci- dental starting causing serious injury.
■Depress spindle lock button and rotate clamp nut until spindle locks.
■Loosen and remove clamp nut from spindle using the wrench provided.
■Remove grinding wheel and disc flange.
■Loosen the clamp screw until you can remove the guard from the bearing cap.
■Place the new guard on the shoulder of the bearing cap.
Note: If the new guard will not fit, loosen the clamp screw until they slide over the bearing cap.
■Rotate guard to the correct position as shown.
Note: Be sure the raised ridge on the guard is seated in the groove on the bearing cap.
■Tighten clamp screw securely.
■Reassemble disc flange, grinding wheel, and clamp nut. Refer to "Installing Accessory Wheels" earlier in this manual.
■Tighten the clamp nut securely with the wrench provided.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
Lubrication
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the tool under normal operating conditions. Therefore, no further lubrication is required.
Fig. 9
15