RIDGID R8411501 manual Installing Battery Pack, Removing Battery Pack, Variable Speed

Page 12

OPERATION

INSTALLING BATTERY PACK

See Figure 4 - 5.

nLock the switch trigger on the drill by placing the direction of rotation (forward-reverse) selector in center position.

nPlace battery pack in the drill. Align raised rib on battery pack with the groove inside the drill.

nMake sure the latches on each side of your battery pack snap in place and battery pack is secured in the drill before beginning operation.

CAUTION:

When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installation of the battery pack can cause damage to internal components.

REMOVING BATTERY PACK

See Figure 4 - 5.

nLock the switch trigger on the drill by placing the direction of rotation selector in center position.

nLocate latches on side of battery pack and depress to release battery pack from the drill.

nThe battery pack will automatically disconnect in direction to be removed when buttons are depressed.

nRemove the battery pack from the drill.

WARNING:

Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.

SWITCH TRIGGER

See Figure 6.

To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

VARIABLE SPEED

See Figure 6.

This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

FORWARD/REVERSE/LOCK OFF

SELECTOR

Fig. 4

DEPRESS LATCHES TO

RELEASE BATTERY PACK

Fig. 5

VARIABLE SPEED

SWITCH TRIGGER

Fig. 6

12

Image 12
Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaSpecific Safety Rules ServiceSafety Rules for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Features Product SpecificationsDepth Gauge ROD Keyless Chuck Assembly Operation Power Indicator Evaluate Indicator Charging Full LED Function of ChargerInstalling Battery Pack Removing Battery PackVariable Speed Reversible TWO-SPEED Gear TrainInstalling Bits Removing BitsUnlock Release Lock Tighten Installing Depth Gauge ROD Adjustable Torque ClutchAdjusting Torque To Increase TorqueDrilling To Adjust Drilling or Hammer Mode Wood DrillingMetal Drilling Masonry DrillingMaintenance General MaintenanceChuck Removal Mallet Chuck Jaws Keyless HEX KEY Wrench ScrewdriverKeeping the Charger Vents Clean Battery Pack Removal Preparation for RecyclingTo Retighten a Loose Chuck BatteriesWarranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredPage Customer Service Information