RIDGID R8411503 manual LED Function of Charger, RED LED Green LED, Evaluate Indicator Defective

Page 11

OPERATION

LED FUNCTION OF CHARGER

See Figure 3.

LED

BATTERY

RED

GREEN

ACTION

INDICATOR

PACK

LED

LED

 

Power

Without battery pack

ON

OFF

Ready to charge battery pack

 

 

 

 

When battery pack reaches cooled

Evaluate

Hot battery pack

Flashing

OFF

temperature, charger begins fast

 

 

 

 

charge mode.

 

 

 

 

When battery pack reaches warmed

Evaluate

Cold battery pack

Flashing

OFF

temperature, charger begins fast

 

 

 

 

charge mode.

 

 

 

 

Charger pre-charges battery until

Evaluate

Deeply discharged

Flashing

OFF

normal voltage is reached, then

 

 

 

 

begins fast charge mode.

Defective

Defective

Flashing

Flashing

Battery pack or charger is defective

• If defective, try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED status repeats a second time, try charging a different battery.

• If a different battery charges normally, dispose of the defective pack (see Maintenance section).

• If a different battery also indicates “Defective,” the charger may be defective.

 

 

Charging

Fast charging

ON

Flashing

See chart below for charge times

 

 

 

 

 

 

 

 

 

Full

Slow charging

OFF

ON

Fast charging is complete;

 

 

 

 

 

 

charger maintains charge mode

 

 

 

 

 

 

 

 

 

 

 

 

 

RED LED

GREEN LED

POWER

 

 

INDICATOR

EVALUATE

INDICATOR

DEFECTIVE

INDICATOR

CHARGING

INDICATOR

BATTERY

AVERAGE CHARGE TIME

 

 

COMPACT SERIES

18 min.

 

 

HC

27 min.

 

 

HC 2.5

34 min.

 

 

FULL INDICATOR

NOTE: The 9.6 Volt, 12 Volt, and 14.4 Volt battery packs will not slide all the way down onto the charger port. Insert 9.6 Volt, 12 Volt, and 14.4 Volt battery packs until they click into place and are aligned with the line on the charger, shown at left.

Allow up to 5 seconds for the “charge” light to come on after the battery pack is inserted.

Fig. 3

Image 11
Contents OPERATOR’S Manual Introduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyService Specific Safety RulesSafety Rules for Charger Important Safety InstructionsName DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning TWO-SPEED Gear Train FeaturesProduct Specifications Forward Torque Adjustment RingAssembly Operation LED Function of Charger Evaluate Indicator DefectiveIndicator Battery Average Charge Time Full IndicatorDepress Latches to Release Battery Pack To Install Battery PackRemoving Battery Pack Switch TriggerChuck Jaws Lock Tighten TWO Speed Gear Train HI-LO HI Speed Drill BITSelecting Hammer Mode or Drilling Mode Adjustable Torque ClutchAdjusting Torque Removing Bits Installing BitsRotation Using the Auxiliary Handle AssemblyDrilling Masonry Drilling Wood DrillingMetal Drilling Batteries MaintenanceGeneral Maintenance Battery Pack Removal and Preparation for RecyclingMallet Chuck Jaws HEX KEY Screwdriver To Retighten a Loose ChuckPage HOW to Obtain Service What is not Covered WarrantyDAY Satisfaction Guarantee Policy What is Covered Under the 3 Year Limited Service WarrantyCustomer Service Information