RIDGID R8411503 manual General Maintenance, Batteries

Page 18

MAINTENANCE

WARNING:

When servicing use only identical RIDGID replacement parts. Use of any other parts may create a hazard or cause product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.

WARNING:

To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a RIDGID authorized service center.

BATTERIES

The battery pack for this tool is equipped with nickel- cadmium rechargeable batteries. Length of service from each charging will depend on the type of work you are doing.

The batteries in this tool have been designed to provide maximum trouble-free life. However, like all batteries, they will eventually wear out. Do not disassemble battery pack and attempt to replace the batteries. Handling of these batteries, especially when wearing rings and jewelry, could result in a serious burn.

To obtain the longest possible battery life, we suggest the following:

Remove the battery pack from the charger once it is fully charged and ready for use.

For battery pack storage longer than 30 days:

Store the battery pack where the temperature is below 80°F.

Store battery packs in a “discharged” condition.

BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING

To preserve natural resources, please recycle or dispose of batteries properly.

This product contains nickel-cadmium

batteries. Local, state or federal

laws may prohibit disposal of nickel- cadmium batteries in ordinary trash.

Consult your local waste authority for information regarding available recycling and/or disposal options.

WARNING:

Upon removal, cover the battery pack’s terminals with heavy-duty adhesive tape. Do not attempt to destroy or disassemble battery pack or remove any of its components. Nickel-cadmium batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

18

Image 18
Contents OPERATOR’S Manual Table of Contents IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaSpecific Safety Rules ServiceImportant Safety Instructions Safety Rules for ChargerSymbols Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Forward Torque Adjustment Ring FeaturesProduct Specifications TWO-SPEED Gear TrainAssembly Operation Full Indicator Evaluate Indicator DefectiveIndicator Battery Average Charge Time LED Function of ChargerSwitch Trigger To Install Battery PackRemoving Battery Pack Depress Latches to Release Battery PackDrill BIT Chuck Jaws Lock Tighten TWO Speed Gear Train HI-LO HI SpeedAdjustable Torque Clutch Adjusting TorqueSelecting Hammer Mode or Drilling Mode Installing Bits Removing BitsUsing the Auxiliary Handle Assembly DrillingRotation Wood Drilling Metal DrillingMasonry Drilling Battery Pack Removal and Preparation for Recycling MaintenanceGeneral Maintenance BatteriesTo Retighten a Loose Chuck Mallet Chuck Jaws HEX KEY ScrewdriverPage What is Covered Under the 3 Year Limited Service Warranty WarrantyDAY Satisfaction Guarantee Policy HOW to Obtain Service What is not CoveredCustomer Service Information