OPERATION
TO INSTALL BITS
See Figures 10 and 11.
Unplug your drill.
WARNING:
Failure to unplug your drill could result in acciden- tal starting causing serious injury.
Open or close the chuck jaws to a point where the opening is slightly larger than the drill bit you intend to use. Also, raise the front of your drill slightly to keep the drill bit from falling out of the chuck jaws.
Insert drill bit into chuck the full length of the jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as shown in figure 7. This could cause drill bit to be thrown from your drill resulting in possible serious personal injury or damage to your chuck.
Tighten the chuck jaws on drill bit.
To tighten: grasp the chuck collar and rotate it to the right. Release the chuck collar and then turn the chuck body to the left.
Note: Rotate the chuck body in the direction of the arrow marked GRIP to tighten chuck jaws.
Do not use a wrench to tighten or loosen the chuck jaws.
TO REMOVE BITS
Unplug your drill.
WARNING:
Failure to unplug your drill could result in acci- dental starting causing serious injury.
Loosen the chuck jaws from drill bit.
To loosen: grasp the chuck collar and rotate it to the left. Release the chuck collar and then turn the chuck body to the right.
Note: Rotate the chuck body in the direction of the arrow marked RELEASE to loosen chuck jaws.
Do not use a wrench to tighten or loosen the chuck jaws.
Remove drill bit from chuck jaws.
RELEASE (UNLOCK)
CHUCK JAWS
CHUCK
COLLAR
CHUCK GRIP
BODY (TIGHTEN)
DRILL BIT
RIGHT
Fig. 10
WRONG
Fig. 11
12