OPERATION
TO INSTALL BATTERY PACK
See Figure 4.
nPlace the battery pack in the impact driver, aligning raised rib on battery pack with groove in the driver’s battery port.
nMake sure the latches on each side of the battery pack snap into place and the battery pack is secured to the impact driver before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the impact driver and latches into place properly.
RAISED RIBS
LATCHES
Improper installation of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 5.
nLocate the latches on the side of the battery pack and depress both sides to release the battery pack from the impact driver.
nRemove the battery pack.
WARNING:
Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.
SWITCH TRIGGER
See Figure 6.
n To turn the impact driver ON, depress the switch trigger.
nTo turn it OFF, release the switch trigger.
VARIABLE SPEED
See Figure 6.
This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
DEPRESS LATCHES TO RELEASE BATTERY PACK
Fig. 4
Fig. 5
12