RIDGID MS1250LZ manual Assembling LEG Stand, See Figures 9

ASSEMBLY

ASSEMBLING LEG STAND

See Figures 9 - 10.

nSeparate brace pieces (letters A, C, D, and E) from leg pieces (letter E). There are a total of 12 pieces: 8 brace pieces and 4 leg pieces.

nRemove the following hardware from the leg stand hard- ware bag:

24 carriage bolts (5/16-18 x 5/8 in.)

4 rubber feet

4 hex bolts (5/16-18 x 2-1/2 in.)

4 flat washers

28 hex nuts (5/16-18)

nPlace leg (B) inside upper side brace (C).

nAlign holes on brace (C) with the holes on leg (B). Insert two carriage bolts and hand tighten using hex nuts.

nPlace lower side brace (D) inside leg (B).

nAlign holes on lower side brace (D) with the holes on leg

(B). Insert carriage bolt and hand tighten using hex nut.

UPPER SIDE

BRACE (C)

LEG (B)

LOWER

SIDE

BRACE (D)

HEX NUT

RUBBER

FOOT

nAttach a second leg (B) to the other side of upper side brace (C) using two carriage bolts and hex nuts.

nNext, align holes on lower side brace (D) with the holes on the second leg (B). Insert carriage bolt and hand tighten using hex nut.

nRepeat the above steps once.

This completes two of the four sides of the leg stand.

nPlace upper brace (A) on top of upper side brace (C).

nAlign holes on upper brace (A) with the holes on leg (B). Insert carriage bolt and hand tighten using hex nut.

nPlace lower brace (E) inside leg (B).

nAlign holes on lower brace (E) with the holes on leg (B). Insert carriage bolt and hand tighten using hex nut.

nRepeat the above steps for the other side of the upper brace then repeat the steps for the opposite side of the leg stand.

nPlace one rubber foot on the bottom of each leg (B).

nUsing a wrench, securely tighten all hex nuts.

This completes the leg stand.

UPPER

BRACE (A)

LEG (B)

LOWER

BRACE (E)

CARRIAGE

BOLT

LEG (B)

Fig. 9

15