Emerson CF720ORB00, CF720WB00, CF720PW00 owner manual PIN Hanger Ball Downrod Setscrew

BP7309 BANFF 1/5/06 9:59 AM Page 6

3. Carefully position a M5 x 16mm oval head screw in one flange hole and loosely tighten the screw (Figure 2). Install the second screw in the same manner and securely tighten both screws. Repeat steps 2 and 3 for the remaining four blade assemblies.

NOTE: Take care not to scratch the fan housing when installing the blade assemblies.

4. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 3). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 10.

PIN

HANGER

BALL

DOWNROD

SETSCREW

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 4) could result in the fan falling.

DOWNROD
CLEVIS	HAIRPIN
PIN	CLIP
	MOTOR
MOTOR AND	COUPLING
HOUSING
UPLIGHT
ASSEMBLY

SETSCREW (2)

REMOVE THREE M4 x 12mm

PAN HEAD SCREWS AND

RUBBER WASHERS

Figure 4

Figure 3

5. Unscrew the two setscrews (Figure 4) until they clear the inside of the motor coupling. Then separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 4). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.

6. Tighten the two setscrews (Figure 4) securely while pulling up on the downrod.

7. Remove and retain three M4 x 12mm pan head screws and rubber washers from the motor and housing uplight assembly (Figure 4).

8. Place the upper glass on the motor and housing uplight assembly. Line up the three holes in the upper glass with the three threaded holes in the motor and housing uplight assembly (Figure 5). Install an M4 x 12mm pan head screw and rubber washer in each of the holes (Screws and rubber washers were removed in step 7).

6