RIDGID R3120 manual Operation, LOCK-ON Button Switch

Page 10

OPERATION

WARNING:

The tool should never be connected to a power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when the tool is not in use. Disconnecting the tool will prevent accidental starting that could cause serious injury.

WARNING:

Always wear eye protection marked to comply with ANSI Z87.1. Failure to do so could result in dust, shavings, or loose particles being thrown into your eyes, resulting in possible serious injury.

WARNING:

To avoid serious personal injury, do not use saw without chip shield properly in place.

Switch

See Figure 3.

To turn the saw ON, depress the switch trigger. Release switch trigger to turn the saw OFF.

Lock-On Button

See Figure 3.

The saw is equipped with a lock-onfeature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your saw will continue running.

To release the lock, depress the switch trigger and release.

If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, disengage the lock-on feature immediately.

WARNING:

Before connecting the saw to power supply source, always check to be sure it is not in lock-on posi- tion (depress and release switch trigger). Failure to do so could result in accidental starting of the saw resulting in possible serious injury. Also, do not lock the trigger on jobs where the saw may need to be stopped suddenly.

LOCK-ON BUTTON

SWITCH

Fig. 3

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Operators Manual Table of Contents IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaService Specific Safety RulesAdditional Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONSpecifications ElectricalUnpacking ApplicationsRecessed Blade-Support Roller FeaturesSwitch Vacuum Attachment Chip ShieldAssembly To Install Jig Saw BladesLOCK-ON Button Switch OperationVariable Speed Splinter-Free CuttingVariable Speed Control Selector General Cutting HEX KEY To Increase Orbital SettingHex Key Storage Do Not Force The SawStraight Cut To Increase Orbital Setting To DecreaseOrbital Motion Scroll CuttingPivot Screw Angle Cutting Bevel CuttingHEX KEY To Make a Plunge Cut Plunge CuttingMetal Cutting Dustless Feature Vacuum AttachmentGeneral MaintenanceLubrication Page Warranty DAY Satisfaction Guarantee PolicyCustomer Service Information
Top Page Image Contents