Emerson CF712WW01, CF712BS01, CF712TZ01 Installing The Light Fitter Glass, Bowl cap Figure

2.Mount one blade assembly to the motor hub by mating the alignment post (Figure 12) of the flange with one of the alignment slots in the motor hub (Figure 13). Then tighten the two captive screws in the flange to secure the flange to the motor hub. Repeat this procedure for the other four blade assemblies. Make sure all screws are tightened.

MOTOR HUB

	BLADE FLANGE
CAPTIVE	ALIGNMENT
SCREW (2)
	SLOT

Figure 13

5.Attach the switch housing cover with light fitter to the switch housing using the three previously removed screws.

!WARNING

To avoid fire or electrical shock, be careful not to pinch wires between the switch housing assembly and the cover.

	SCREW (3)
WHITE WIRE	BLUE WIRE
WIRE	WIRE
CONNECTOR
	CONNECTOR
WHITE WIRE
NUT	BLACK WIRE
LOCKWASHER	SWITCH
	HOUSING
	COVER

Installing The Light Fitter

And Glass

Figure 15

LIGHT FITTER

1.Remove and retain the three screws securing the switch housing cover to the switch housing. (Figure 14) Remove and retain the two wire connectors. Remove plug screw.

6.	Install three 60-watt (maximum) candelabra base
	light bulbs (not supplied) into the light fitter sockets
	(Figure 16).
7.	Remove the finial nut and outer bowl cap from the
	light fitter (Figure 16).

SWITCH

HOUSING

REMOVE AND RETAIN THE TWO WIRE CONNECTORS

SCREW (3)

SWITCH HOUSING COVER

8. Pass the fan switch chain through the bushing in

the bowl cap (Figure 16).

!WARNING

To avoid possible fire hazard, do not exceed wattage indicated on the fitter.

Figure 14

PLUG SCREW

FAN SWITCH CHAIN

2.Remove and retain the lockwasher and nut from the light fitter. Insert the black and white wires from the light fitter through the center hole in the switch housing cover. Thread the switch housing cover onto the light fitter. Reinstall the lockwasher and nut and tighten securely (Figure 15).

3.Connect the white wire from the ceiling fan to the white wire of the light fitter (Figure 15). Connect the blue wire from the ceiling fan to the black wire of the light fitter. Use wire connectors (previously removed) to make connections.

4.Carefully tuck all wires and splices into the switch housing.

LIGHT FITTER

BOWL CAP

THREADED NIPPLE

OUTER BOWL CAP

FINIAL NUT

LIGHT SWITCH

CHAIN

60-WATT

CANDELABRA BASE BULBS (3)

GLASS BOWL

PENDANTS (2)

8 Figure 16 U.L. Model No.: CF712