Emerson CF804SWW 00, CF805SBS 00 How To Put Your Ceiling Fan Together, Using Your Ceiling Fan

How To Put Your Ceiling Fan Together

1. Align the four holes in the fan housing with the holes in the mounting plate and install four 3/16-24 x 3/8" screws (Figure 6).

3/16-24 x 3/8" SCREW

FAN

HOUSING

Figure 6

2. Mount the blade flanges to the fan blades using three 3/16-24 x 9/32" washer head screws per blade (supplied) (Figure 7). Repeat for four remaining blades.

!WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

3. Attach one blade assembly to the motor using two 1/4-20 x 1/2" phillips head screws (supplied) (Figure 8). Make sure the screws are tightened securely. Repeat this procedure for the other four blade assemblies.

3/16-24 x 9/32" WASHER HEAD SCREWS (3)

	BLADE
	FLANGE
Figure 7	FAN BLADE

NOTE: Take care not to scratch the fan housing when installing the blade assemblies.

BLADE

	BLADE FLANGE
Figure 8	1/4-20 x 1/2" SCREWS (2)

4.You have now completed the assembly of your new ceiling fan.

Using Your Ceiling Fan

!	WARNING
To reduce the risk of fire or electrical shock, do not
use this fan with any solid-state speed control
device.
1. Restore electrical power to the electrical box by
turning the electricity on at the main fuse box or
circuit breaker panel.
2. Check the operation of the fan by gently pulling on
the pull chain switch.		SPEED
3. All fans are shipped from the factory with the re-
		CONTROL SWITCH
versing switch positioned to circulate air downward.
If airflow is desired in opposite direction, turn your		THREE SPEED:
fan off and wait for the blades to stop turning, then
slide the reversing switch to opposite position, and		1st Pull – High
turn fan on again. The fan blades will turn in the		2nd Pull – Medium
opposite direction and reverse the airflow.		3rd Pull – Low
Your fan model is equipped with a 4-position,		4th Pull – OFF
3-speed pull chain switch. The operating sequence		6 Figure 9
is as follows:

REVERSING SWITCH