This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver | One stepladder |
One 1/4” blade screwdriver | One wire stripper |
One 5/16” open end wrench, or pliers
Three wire connectors (supplied).
Materials
Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a
Installed Wire Length | Wire Size A.W.G. |
Up to 50 ft. | 14 |
| 12 |
!WARNING
Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 9). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.
Ceiling Fan Assembly
1. Remove the hanger ball by loosening the setscrew in |
the hanger ball until the ball falls freely down the |
downrod (Figure 1). Remove the pin from the |
downrod, then remove the hanger ball. Retain the pin |
and hanger ball for reinstallation in step 4. |
2. Separate, untwist and unkink the three 80” motor |
leads. Route the motor lead wires through the |
downrod. Align the clevis pin holes in the downrod |
with the holes in the motor coupler. Install the clevis |
pin and secure with the hairpin clip (Figure 2). The |
clevis pin must go through the holes in the motor |
coupler and the holes in the downrod. Be sure to |
push the straight leg of the hairpin clip through the |
HANGER BALL
SETSCREW
Figure 1
PIN
DOWNROD
hole near the end of the clevis pin until the curved |
portion of the hairpin clip snaps around the clevis pin. |
The hairpin clip must be properly installed to prevent |
the clevis pin from working loose. Pull on the |
downrod to make sure the clevis pin is properly |
installed. |
!WARNING
It is critical that the clevis pin in the motor coupler is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling.
3.While pulling up on the downrod, securely tighten the two setscrews in the motor coupler.
| MOTOR |
| |
| COUPLING |
| |
SETSCREW | HAIRPIN |
| |
CLEVIS PIN | DOWNROD | ||
CLIP | |||
JAM NUT |
| HAIRPIN CLIP | |
MOTOR |
| ||
|
| ||
COUPLING |
| SETSCREW | |
|
| ||
CLEVIS PIN |
|
| |
Figure 2 |
|
|
4 | U.L. Model No.: CF772 |