Emerson CF750ORB00 owner manual Emerson

BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 13

Setting Operating	Battery Installation of
Frequency of Wall	Wall Control
Control and Receiver
	! WARNING
(Figure 24)

Your wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Change the switch settings as follows:

1. Slide the four switch levers in the wall control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2. In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box.

The wall control transmits the command signals via radio waves to the SW105 receiver installed in the ceiling fan ceiling cover. The SW105 receiver is required for the wall control to function. Power for the wall control comes from the 12V battery, located in the wall control.

Replacement 12V batteries recom- mended are Duracell MN21, Eveready A23, and GP23A.

1. Install the 12V battery (supplied) into the wall control (Figure 25).

2. The wall control is supplied with a white or almond color cover. Choose the style that best suits your needs and snap the cover onto the wall control (Figure 25).

SW105 RECEIVER

CODE

SWITCH

WALL CONTROL

LEVERS

4	3	2	1
			ON

ON

1 2 3 4

RECEIVER SWITCH

LEVERS

HIHI

LIGHT

MEDMED

LOWLOW

FAN OFF

WALL CONTROL

CODE SWITCH

Figure 24

WALL

CONTROL

	HIHI
U/L	LIGHT
	MEDMED
	LOWLOW
D/L	FAN OFF

EMERSON

12V BATTERY

WALL CONTROL COVER

Figure 25

13