Your laser level requires two AAA batteries (not supplied). Batteries are available at your local RadioShack store or online at www.radioshack.com.
• Keep the laser level dry. If it gets wet, wipe it dry |
immediately. |
laser level
Your RadioShack Laser Level is a high quality laser level incorporating advanced laser optics and microelectronics. The machined aluminum body of the laser level is equipped with two high quality bubbles, one horizontal and one vertical. Every laser level must pass a critical vibration test before leaving the factory. This test assures the accuracy of the laser within 0.2 inches (5.08mm) at a distance of 30 feet (9.1m).
1.Remove the battery cover by turning
2.Arrange the batteries in the compartment as indicated by the polarity symbols (+ and
battery notes
•When the laser beam dims, or stops operating properly, replace the batteries.
•Dispose of old batteries promptly and properly. Do not burn or bury them.
•Use only fresh batteries of the required size and recommended type. Do not mix batteries of different types, capacities, or chemistries.
•If you do not use your laser pointer for several days, remove the batteries. Batteries can leak chemicals that may destroy electronic parts.
• Use and store the laser level only in normal |
temperature environments. Handle the laser level |
away from dust and dirt, and wipe it with a damp |
cloth occasionally to keep it looking new. |
• Modifying or tampering with the laser level’s internal |
components can cause a malfunction and might |
invalidate its warranty. |
• If your laser level is not performing as it should, take |
it to your local RadioShack store for assistance. |
using your laser pointer
1.Press the ON/OFF button on the battery cover to turn the laser level on.
2.Place the laser level on the reference object with the base touching.
3.Aim at the object you want to measure.
4.Slide the lens toward the dot () to project a laser DOT.
vertical | horizontal |
bubble | bubble |
Slide the lens toward the line
When the vertical or the horizontal bubble is between the two black lines and the laser level itself is level, the projected line or dot is either vertical or horizontal.
tips
1. Make sure that the laser level itself is level before you work from the laser beam reference point. To do this, place the laser level on your reference surface.
2. You can use the laser level on a tripod with the hole on the bottom of the level.
ON/OFF
switch and
battery
cover
dot
lens: slide
up/down to project line/dot
line
Thank you for purchasing your laser level from RadioShack.
Laser Level
User’s Guide
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one (1) year from the date of purchase from RadioShack
RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102 04/04
important safety precautions
•Warning! Never point the laser at anyone.
•Warning! Follow the instructions on the danger label.
•Warning! Never look directly into the laser beam.
•Warning! Keep laser pointer away from children.
•Warning! Use of controls or adjustments, or the performance of procedures other than specified herein, can result in hazardous radiation exposure.
•Warning! Laser light, when reflected by a
Actual product may vary from the images
NOTE | found in this document. |
|
Please read this user’s guide before | ©2004. RadioShack Corporation. | ||
All rights reserved. RadioShack and | |||
installing, setting up and using your new product | 06A04 | ||
RadioShack.com are trademarks | |||
www.radioshack.com | used by RadioShack Corporation. | Printed in China |
product specifications
Laser Type | IndexGuided |
Wavelength | 650±10nm (Class IIIA Product) |
Output Power | <5mW |
Operation Range | >600 feet |
Battery LIfe | 25 hrs (alkaline) |
Beam type | Dot or Horizontal |
Material | Aluminum |
Specifications are subject to change and improvement without notice. Individual units may vary.