Makita SK20SP instruction manual Operation, Attaching and replacing batteries

Page 4

Attaching and replacing batteries (Fig.1)

Fig. 1

Makita SK20 exclusive uses Elevating Tripod.

Fig. 2

OPERATION

Horizontal

Fig. 4

Press the H button. The unit projects the horizontal laser-beam line as illustrated in Fig.4.

You can adjust the height of the horizontal laser line by mounting the unit to Elevating tripod provided

(See the Fig. 2)

Vertical + Right angle (Vertical) + Plumb Point (floor)

Fig. 5

Fig. 3

1.Turn on the power switch (12). The unit (laser level) projects the horizontal laser- beam line.

2.If the unit is placed in a slanting position, it will not emit any laser lines at all. Adjust the level adjusting ring (9) so that the air-bubble in the round vial (4) is centered. (See the Fig. 3)

3.If you work with the receiver (optional accessory),

press the interior/exterior mode change button (2). Exterior mode indicator LED (green) (3) will light on.

Following 3 operation modes are available. Press the most suitable operating-mode selecting button

(1) according to your job.

Press the 2V button. The unit projects the vertical laser-beam lines as illustrated in Fig.5.

Vertical + Right angle (Vertical) + Horizontal + Plumb Point (floor)

Fig. 6

Press the 2V/H button. The unit projects the laser-beam lines (2 vertical and horizontal ones) as illustrated in Fig.6.

4.Turn off the power switch after operation. The unit will be automatically locked.

4

Image 4
Contents Laser Level Specifications Safety InstructionsSymbols For safe operationUse and care for laser level Explanation of general viewAttaching and replacing batteries OperationVertical + Right angle Vertical + Plumb Point floor Inspection of the leveling accuracy of the laser level Page Page Makita Corporation