BP7305 Westfield 6/30/06 12:10 AM Page 6
6. Remove and retain one of the three pan head screw/lockwashers from the motor flange (Figure 2); loosen the other two pan head screws three or four turns.
7. Position the switch cup adapter on the motor flange so that the two screws mate with the two keyhole slots in the switch cup adapter (Figure 2).
NOTE: Make sure that the lockwashers are positioned between the screw head and the switch cup adapter.
8. Turn the switch cup adapter clockwise and tighten both screws (Figure 3). Reinstall the other pan head screw/ lockwasher in the remaining hole in the switch cup adapter.
INSTALL ONE PAN HEAD
SCREW/LOCKWASHER
MOTOR FLANGE | SWITCH CUP |
| ADAPTER |
LARGE
CONNECTORSSWITCH CUP ASSEMBLY
SMALL
CONNECTORS
Figure 4
10. Position the switch cup assembly on the switch cup adapter. Line up the three holes in the switch cup with the threaded holes in the switch cup adapter and install four
CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the switch cup adapter and switch cup assembly.
TIGHTEN TWO PAN
HEAD SCREWS
Figure 3
9. Carefully rest the switch cup assembly on the fan blades, then engage the large
PULL CHAIN
PENDANT
COUPLING
SWITCH CUP ADAPTER
SWITCH CUP ASSEMBLY
connector. The two connectors are keyed and
8-32 x 1/4" PAN HEAD SCREW (4)
Figure 5
6