!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
3.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket.
4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 13).
5.Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 13.) Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.
Using Your Ceiling Fan
1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.
2.Check the operation of the light by gently pulling on the light switch pull chain.
3.Check the operation of the fan by gently pulling on the speed control switch pull chain. The operation sequence is as follows:
1st pull - High | 3rd pull - Low |
2nd pull - Medium | 4th pull - OFF |
4.Your fan is shipped from the factory with the reversing switch positioned to circulate air downward. If airflow is desired in opposite direction, turn the fan off and wait for the blades to stop turning, then slide the reversing switch to the opposite position, and turn the fan on again. The fan blades will turn in the opposite direction and reverse the airflow.
| CEILING COVER |
THREADED STUD | LOCKWASHER |
| |
KNURLED KNOB |
|
Figure 13
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
6.Cut the
REVERSING 
SWITCH
SPEED CONTROL
LIGHT PULLPULL CHAIN SWITCH CHAIN SWITCH
8 | U.L. Model No.: CF701 |