Using The All-Position Leveling Base

To use the All-Position Leveling Base in conjunction with the Patm Grip Laser Level, it is best to place the level on the base for preliminary alignment of the laser line on the wail.

1.Without turning the Laser Level on, place it on the Al_-Position Leveling Base.. 3_vo magnets (one in the bottom of the laser and one in the top of the base) hold the base and the level together_ This sphedcaVmagnetic design allows adjustment for horizontal (level) and vertical (plumb) of the laser line..

2.Once the level is on the base, turn the level "ON" being careful not to point the laser line in the direction of anyone's eyes including your own..

3o Place the level/base assembly on the wall and position the line across the surface(s) and at the approximate height you want to draw a level line,

Leveling The Palm Grip Laser Level On

All-Position Leveling Base (See Fig. 10)

There are two level vials (x, y) on the top of the Palm Grip Laser Level and a third vial located on the side (z) of the laser level (Fig° 1 #5)° With the AIFPosition Leveling Base and the Palm Grip Laser Level connected, align the bubble of one or both of the (x,y) or (z) vials° This will allow for horizontal (level) or vertical (plumb) level adjustments (Fig. !0),

Fig. 10

48291 Manual_Rev'ise_06,.0907

Page 9