OPERATION
TO ASSEMBLE BLADE
1.UNPLUG YOUR SAW.
2.Remove blade wrench from storage area, See Figure 2,
3.Position your saw on end of motor housing and remove blade screw. NOTE: Turn blade screw
counterclockwise to remove.
4.Remove spring washer and "D" washer.
BLADE WRENCH | LOWER | BLADE |
STORAGE | GUARD | HANDLE |
| SPINDLE |
|
OUTER BLADE "D" WASHER
SPRING
WASHER
LOWERINNER
BLADEBLADE
GUARDWASHER
BLADE
BLADE
. Fit saw blade inside blade guard and onto spindle. NOTE: The saw teeth point upward at the front of
saw.
,Replace "D" washer and spring washer. NOTE:
"Cupped" side of spring washer goes against outer blade "D" washer. See Figure 2,
,Replace blade screw and tighten until spring washer is flattened. NOTE: Turn blade screw
clockwise to tighten.
. Return blade wrench to storage area. NOTE: Always place angled portion of blade wrench up as shown in figure 2.
TO REMOVE BLADE
1.UNPLUG YOUR SAW.
2.Remove blade wrench from storage area. See Figure 2.
3.Place your saw on a piece of scrap wood as shown in figure 3 with the blade teeth embedded in the wood.
OUTSIDE OF SPRING WASHER
CUPPED SIDE AGAINST
OUTER BLADE "D" WASHER
Fig. 2
TOP LOCK SWITCH
LOWER BLADE
GUARD HANDLE
/
BLADE
WRENCH
X
, Turn blade screw counterclockwise | and remove. |
|
5, Remove spring washer, "D" washer, and blade. | BLADE SCREW | |
| ||
Before replacing blade, wipe a drop of oil onto |
| |
washers where they contact blade. |
|
|
, Return blade wrench to storage | area. NOTE: | Fig. 3 |
Always place angled portion of blade wrench up |
| |
as shown in figure 2. | Page 6 |
|