OPERATION
TO POCKET CUT (Cont'd.)
After you complete your cut release the trigger and
allow the blade to come to a complete stop. DO NOT REMOVE YOUR SAW FROM WORKPIECE WHILE
THE BLADE IS MOVING.
Corners may then be cleaned out with a hand saw or sabre saw.
TO BEVEL | CUT |
|
|
|
|
|
|
| ||
The angle of cut of your saw may be adjusted to any | TOP VIEW |
| ||||||||
desired setting between zero and 45 degrees. There |
| |||||||||
OF SAW |
| |||||||||
is a notch in the saw base to help you line up the |
| |||||||||
|
| |||||||||
blade with the line of cut. See Figure 15. Align your | MOTOR | |||||||||
line of cut with | the inner | edge of the notch in the saw | ||||||||
base when making full 45 degree bevel cuts. Since |
| ISING | ||||||||
|
| |||||||||
the thickness of blades vary and different angles re- | BEVEL | SCALE | ||||||||
quire | different | settings, | always | make a trial | cut in | |||||
scrap material | along a | guideline | to | determine | how | WING |
| |||
much | you should offset | the guideline | on the board to |
| ||||||
be cut. |
|
|
|
|
|
|
|
| ||
When making a bevel cut hold your saw firmly with |
|
| ||||||||
both | hands | as | shown | in Figure | 16. | Rest the | front |
|
| |
edge | of the base on the work. | Push | in the | NOTC[ IN | _ | |||||
button and squeeze the switch trigger. ALWAYS LET | SAW BASE | |||||||||
THE BLADE REACH FULL SPEED, THEN GUIDE | ||||||||||
|
| |||||||||
YOUR SAW INTO THE WORK. |
|
|
| GUIDELINE |
| |||||
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ALIGN INNER EDGE OF NOTCH IN SAW | ||
|
|
|
|
|
|
|
| BASE WITH LINE OF CUT AS SHOWN | ||
|
|
|
|
|
|
|
| WHEN MAKING 45 ° BEVEL CUTS | ||
|
|
|
|
|
|
|
|
| Fig. 15 | |
After you complete your cut release the trigger and |
|
| ||||||||
allow the blade to come to a complete stop. DO NOT |
|
| ||||||||
REMOVE YOUR SAW FROM WORKPIECE WHILE |
|
| ||||||||
THE | BLADE | IS MOVING. |
|
|
|
|
|
| ||
TO ADJUST | BEVEL SETTING |
|
|
|
|
| ||||
1.UNPLUG YOUR SAW.
2.Loosen wing nut. See Figure 15.
3.Raise motor housing end of saw until you reach the desired angle setting on bevel scale. See Figure 15.
4.Tighten wing nut securely.
LOWER BLADE
GUARD
,.,.Fig. 16
Page 11