389997 | 11/3/03 2:49 PM Page 9 |
OPERATING INSTRUCTIONS
Using the screw supplied with the accessory guide, position as shown in Figure 5 and thread the screw into the shoe to clamp the fence securely. When circle cutting, adjust rip fence so that distance from blade to hole in cross bar is at the desired radius and tighten screw (use hole which lines up best with saw blade). Place saw so that hole in cross bar is over center of circle to be cut (make pocket cut, drill hole for blade or cut inward from edge of material to get blade into position). When saw is properly positioned, drive a small nail through hole in cross bar. Using rip fence as a pivot arm, begin cutting circle. For circle cutting, the cross bar should be up, as shown in Figure 5. When ripping, slide the rip fence under the screw from either side of the saw.
Set the cross bar at desired distance from blade and tighten screw. For ripping, the cross bar should be down and against the straight edge of the workpiece.
5
ACCESSORIES
Kmart has a large selection of acces- sories for your Jig Saw for most any job application around the home or in your workshop.
CAUTION: Never use acces- sories in your jig saw that are not designed for use in your jig saw.
They may be hazardous and may present a risk of injury to operator.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.
9