Sears 200.71440 Using an extension cord, Preparing your battery to be charged, AWG* Size of Cord

Page 7

A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly grounded outlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualified electrician.

DANGER: Before using an adapter as illustrated, be certain that the center screw of the outlet plate is grounded. The green colored grounding clip of the adapter must be attached by a screw to a properly grounded outlet. If unsure whether outlet is properly grounded, contact a professional electrician. If neces- sary, replace the original outlet cover screw with a longer one that will secure the grounding clip to the outlet cover and make a ground connection to the grounded outlet.

Using an extension cord

The use of an extension cord is not recommended. If you must use an extension cord, please make sure that you follow these guidelines:

•Make sure the pins on the plug of the extension cord are the same number, size, and shape as those of the plug on the charger.

Use only 3-conductor (grounded) extension cord when necessary.

•Check that the extension cord is properly wired and in good electrical condition.

•Use the recommemnded minumum AWG (American Wire Gauge) to be sure that wire size is large enough for the rating of the charger.

MINIMUM RECOMMENDED EXTENSION CORD

Length of Cord, in Feet

25

50

100 150

AWG* Size of Cord

18

14

12

10

*AWG=American Wire Gauge

Preparing your battery to be charged

It is important that you read and follow these guidelines while you are preparing to charge your battery.

•Make sure that you have a 12 volt lead-acid battery. Clean the battery terminals. Be careful to keep corrosion from getting in or around your eyes.

•If you have a battery with removable cell caps, if required, add distilled water to each cell until the battery acid reaches the level indicated by the manufacturer. This will help purge excessive gases from the cells. Be careful not to overfill. If you have a sealed battery without cell caps, no action is neces- sary. Continue to the next step listed below.

•Take time to read all battery manufacturer’s specific precautions, such as removing or not removing cell caps while charging, and recommended rates of charge.

Wear safety glasses. See additional "Personal Safety Precautions" on page 2.

Be sure that the area around the battery is well ventilated while it is being charged. If ventilation is poor, gas can be manually blown away by using a piece of cardboard or other non-metallic material as a fan.

If it is necessary to remove the battery from the vehicle to charge it, always remove the grounded terminal from the battery first. A spark may be caused if all accessories in the vehicle are not completely turned off.

NOTE: A marine battery installed in a boat must be removed and charged on shore.

6

Sears 440 - Sch 516 9/16/95

Image 7
Contents Manual Battery Charger Warranty Table Of ContentsPersonal Safety Precautions Important Safety InstructionsHelp us help you Parts Wiring diagramParts Tools Needed Before Using Your Battery ChargerTo attach the axle assembly Assembling your chargerTo attach the handle Plugging itElectrical Shock Hazard Length of Cord, in Feet Using an extension cordPreparing your battery to be charged Minimum Recommended Extension CordSetting the controls Using Your Battery ChargerOFF Charging your battery in the vehicle Charging Your BatteryONE That is Grounded Charging your battery outside the vehicle Specific Percent Gravity Charge Charge Needed Chart MethodCalculating charge time Hydrometer or Electronic MethodMaintenance and care Using the engine start featureAM to 430 PM CST Monday through Friday TroubleshootingProblem Possible Cause SOLUTION/REASONS SEARS-64SEARS-64