It is important to understand your charger'srequirements. This section will tell you
about your charger's electrical requirements and how to prepare a battery for charging. 2
QUICK DISCONNECT HARNESS
To permanently attach to a small
battery (i.e. motorcycle), connect the red
POSITIVE harness wire eyelet to the POSITIVE battery terminal. Then
connect the black NEGATIVE eye[et toNEGATIVE GROUNDED SYSTEM the NEGATIVE battery terminal.
Loosen and remove each nut from bolts at battery terminal. One at a time, slip the eyelets of the harness wires over the bolt at battery terminal. Replace and tighten nuts to secure.
ELECTRICAL INSTALLATION
Route and secure the output away from gas line, carburetor, or other hot, sharp or moving parts to avoid damaging the wire insutation. Secure the wiring to the
frame or cable using a self locking cable tie or equivalent.
PLUGGING IT IN
Your charger requires a 120V receptacle installed according to all local cedes and ordinances.
USING AN EXTENSION CORD
The use of an extension cord is not
recommended. If you must use an extension cord, please make sure that you follow these guidelines:
•Make sure that the pins on charger's power cord fit firmly into the extension cord, and that the extension cord fits firmly into the receptacle.
•Check that the extension cord is
properly wired and in good electrical condition.
Make sure that the wire size is large enough for its length and for the AC ampere rating, as specified in the chart below.
WARNING: Electrical Shock Hazard. Be sure that the power cord fits properly into the outlet, If not, have a qualified technician install a proper outlet. Never alter the AC cord or plug provided. Improper connection can result in electrical shock.
AWG* Size of COrd | 128 | 16 | 14 | I | |
| 18 | 18 |
| ||
*AWG=Amsfican W_e Gauge
5