Sears 200.71991 operating instructions

Page 8

7.FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE.

A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY:

7.1Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery post usually has a larger diameter than the NEGATIVE (NEG, N, -) post.

7.2Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to the NEGATIVE (NEG, N, -) battery post.

7.3Connect the POSITIVE (RED) charger clip to the POSITIVE (POS, P, +) post of the battery.

7.4Position yourself and the free end of the cable you previously attached to the NEGATIVE (NEG, N, -) battery post as far away from the battery as possible – then connect the NEGATIVE (BLACK) charger clip to the free end of the cable.

7.5Do not face the battery when making the final connection.

7.6When disconnecting the charger, always do so in reverse sequence of the connecting procedure and break the first connection while as far away from the battery as practical.

7.7A marine (boat) battery must be removed and charged on shore. To charge it onboard requires equipment specially designed for marine use.

5

Image 8
Contents OPERATOR’S Manual Page Table of Contents Important Safety Instructions Page Charger Location DC Connection PrecautionsPreparing to Charge Follow These Steps When Battery is Installed in ve- hicle Page Battery charging ac connections Grounding Methods Timer WheelQTY Description Tools NeededPage Hold Operating instructions TimerAMP Rate Selector Switch Engine start AmmeterVoltmeter Calculating charge time Chart Method Charge Rate Battery SIZE/RATING Charging Time Hours AMPHydrometer or Electronic Method Specific Gravity Percent of Charge NeededTo calculate time needed for a charge ExampleMaintenance instructions Storage instructionsTroubleshooting Problem Possible Cause SOLUTION/REASONSProblem Possible Cause SOLUTION/REASONS