10.1First, carefully lay the charger on its front to prepare for assembly.
10.2Assemble the foot (Item 6) using two
10.3Attach the two axle brackets (Item 1) using one
10.4Slide the axle (Item 2) into the brackets (Item 1) until centered on the char- ger.
10.5Slide one wheel (Item 3) onto the axle with the recessed hub facing out as shown.
10.6Next insert pin (Item 8) thru axle hole.
10.7Repeat this process for the other wheel and when both wheels have been pinned to axle, finish tightening the two axle bracket screws (Item 4).
10.8Snap hub caps (Item 7) onto each wheel to cover the pin and axle.
10.9Next lift the charger upright so that it rests on the wheels and foot.
10.10Remove the two top side screws (Item 9) from each side of the charger.
10.11Verify that the foam handle grip (Item 12) is on the handle assembly (Item 10), install if needed.
10.12Insert the fiberglass clamp rod (Item 11) into the pierced holes on the inside of the handle (Item 10).
10.13Align the handle assembly (Item 10) with charger and reinstall the side screws (Item 9). Do not over tighten.
10.14Charger assembly is now complete. Battery clips can be clamped to the fiberglass rod (Item 11) for convenient storage.
10.15Do not attach clips to the foam area of handle as this will damage the foam grip.
• 9 •